Search:

Thanx mactec54. It is logical. I could not even thougt that.:).

Wishes.
Elbruz.

I noticed this drawing from its manual.
There are total 8 holes.I think they are for fixing column to rightside or to leftside according to preference.
But, what can it help to fix column a bit...

Hi all.
While tramming and general maintance my mill, i noticed some holes inside the bed and near the column. I attached the pictures. There are 4 holes inside the bed at backside, and 2 holes in...

Yes, i have been tramming the mill since last two weeks. There has been some minor error. And finally i managed to reduced to 0,02-0,03 mm range. But, when i tighten the upper lock screw of the head,...

Hi all.
My problem is with end mills while surface milling.
As you will see from the attached pictures, after milling, there is RIDGES between the borders of each passes.
Ok, i do not expect a...

Yes right "vegipete":). It was mentioned in order more clearity. But,when i read again and again it makes confusion. So, as you mention "You don't need to do any calculations involving the diameter...

Just a have look at www.maedler.de . Or Small Mechanical Components: Precision Gears, Gear Assemblies, Timing Belts, Timing Belt Pulleys and Couplings - SDP/SI . Hope it helps.

Please accept the following approach that describes how to find the center of a hole with edge finder with a DRO equiped machines. Yes, I know, i did not invent this technique , but honestly to say...

Yes i got it now Steamyrotter. Thnx.
I had better buy a MPG. The easist way i think.
And, by the way i found the following site. It seems to have very reasonable prices.
But, not sure about their...

I am confused. In fact could not manage to explain what i want. Shortly, in order words,basicly i want to use mach3 screen as dro. Yes i know, when it is powered on, steppers do not move and can not...

Its ok. But, for example coordinates are as follow; x:100, y:50. And i drilled a hole. And i want to drill a second hole 20mm apart from first hole. So, if i move the x axis valuee to 120, does it...

Hi All ,

I am a newby and wanna ask a simple question.

In cnc milling machine, how can i use it manually by hand ?
In other words, there is mach3 screen and there is coordinate values on it....

Hi All ,

I am a newby and wanna ask a simple question.

In cnc milling machine, how can i use it manually by hand ?
In other words, there is mach3 screen and there is coordinate values on it....