Hi What are you trying to do,
But try this!
CC X0 Y0
LP PR+100 PA+0 F1000 "Polar radius is quite large, this needs to be half the size of the hole size"
LB2
ICP PA+0 IZ-1 DR- F1500
CALL...
Type: Posts; User: philippritchard
Hi What are you trying to do,
But try this!
CC X0 Y0
LP PR+100 PA+0 F1000 "Polar radius is quite large, this needs to be half the size of the hole size"
LB2
ICP PA+0 IZ-1 DR- F1500
CALL...
Hass mill 2011 model suddenly needs a new back up battery that should of lasted 10 years, but are going pop after just three at an amazing cost of £800 or about $1400, I nearly died when I opened the...
%
O99999 (MILL PROGRAM EXAMPLES)
(TO SEARCH WHAT YOUR LOOKING OR TYPE IN)
(THE RELEVANT N NUMBER THEN PRESS THE CURSOR)
(DOWN KEY)
(N1=SAFETY START LINE) (G40,G80,G00,ETC)
(N2=WORK...
Hi John I have a mini mill and I find it good value for money very power full for its size bad points the control system "g code" is rubbish try to find one with a hiedainan control it so simple and...
I will have a look at my machine tomorrow just check so try f4 scroll down and click transfer file from main prog to usb, I just write progs straight onto the usb stick on my laptop with notepad.
I...
thank you
The machine is only 2 years old and has worked every day and very rarely on the same prog. it does not need dots and splogs as suggested by the coffee man altho the lack of the commer in front of...
20mmx70mmx12mm billet just want to round both ends with a 10mm rad
prog will not run does any one know why when should be such a simple thing to do!
O99998
(SAFETY START LINE)
G90...
I have three 410 & 410 pa it sounds like the encoder on the top off the main spindle motor, give AL machine tools a ring ask for ali .
Take care
Philip
Hope this helps, this is what i use to get me out of trouble copy and paste as a prog into your machine, its a good reference,
%
O99999 (MILL PROGRAM EXAMPLES)
(TO SEARCH WHAT YOUR LOOKING...
Hi i had a shuttle fault problem with a 6 months old Hass mill found the problem to be, as it went into tool change just as the carousel was retreating back the fingers holding the tool would let go...
Hi get a inverter single to 3 phase just make sure its the right ampage,
philip
Hi this control can be used in g code but you will find the user control much simpler than you imagine the canned cycles are straight forward none of this silly g code stuff were you have to cancel...
machine a metal ring to diameter that suits then slip it over the jaws and this will stop them opening to far.
Philip
what machine do you have
Give ali honda a ring AL Machine tools, he knows these machine inside out,
You need to make a lable, defining the cc x0 y0, circular polar with a incremental movement in z and x or y then repeat this in the lable call , hopefully this will have the desired affect.
Check the brushes on your z axsis drive,
Philip
Hi to start with what grade of stainless are you trying to drill, and what size hole or holes are you hopeing to drill, As for the type of drill you should be useing the best are dormer a777 or any...
The only problem with a hass lathe or mill are the programming and the way they have gone about it, its rubbish to put it mildly, if you wish i will paste in there programming cycle's and you can...
hi use an inverter of some kind,