Search:

I need some recomendations on lathe inserts and mill tooling and grades to cut a special alloy i have tried kennametal inserts with only being able to make half a pass and it knocks the corner off....

ok i just nooticed u was in serbia calling the america location may not be a good idea i would call another one of their branch offices and see what they have to say

I will see if i can get a picture of them tommorrow . are all your axis homed out? cause if they arent the table may not index cause of a parameter that is turn on i would suggest calling chiron...

alarm 7009 is this
num:7n09
message: SPN_n_ : OVERHEAT MAIN CIRCUIT
drive alarm:AL to 09
meaning:Excessive load on main circuit section
Description:Detects abnormal temperature rise of power...

there is 2 sensors on the spindle housing one that is about 1/2 in in dia that is an adujustable housing and another one that is lower on the spindle that is about 1/4 in dia .

As far as the...

also look in to mari tool i buy holders from them all the time

if the machine has been crashed you may have to pick up your home postions again mine only throws that alarm when it hits a hard stop

there is a sensor on the spindle houseing that lights up when the tool is in the spindle correctly u can see the light from it from the opertor door its in the area between the #8 and number 10 tool...