Search:

Bar feeder telling SPS no responses x write and also not work. I have work in DOOSAN PUMA TT1800 MS lathe with a LNS quick load servo 3 bar feerer.Any body can help me.

Hi Darry,
can you please help me, i am using PUMA 230MS 18I FANUC CONTROL, i am not able to do Tool Indexing . from some dayz my hydraulic motor do not get ON in the morning or after break of 2 to...

hello,
i am using puma230MS fanuc 18i-t control, few days before my hydraulic was not getting ON so i used to unplugged the solenoid valve near to hydraulic tank and it used to get ON , but since...

Hello guyz,
i am using PUMA 230MS with 21i fanuc control, many times my puma 230ms hydraulic does not get on so in that case i used to unplugged the solenoid coil of turret and sub spindle and the...

Hello Dear ,
I have changed the battery and also set the machine to it reference point , but when ever i turned the machine off and put it on next day the machine shows me same alarm , i have...

Hello,
I have changed the battery and also set the machine to it reference point , but when ever i turned the machine off and put it on next day the machine shows me same alarm , i have changed the...

HI Guys,
I am using Doosan 1800ms lathe , few dayz before machine was having APC alarm also there was alarm on the drive also so i changed the batteries of the drive 3.6volt , error goes away from...

then when you are going in setting there is parameter option not available.
my whatsapp no. +971526305735.

you put mode MDI and then offset key and then setting

Dear,
For changing parameter follow this step
1.. MACHINE IN MDI MODE
2. press softkey OFFSET than press Setting
3. Parameter WRITE ENABLE -- MAKE IT 1 FROM 0
4. NOW YOU CAN GO TO SYSTEM AND...

Dear all,
I have DOOSAN TT1800MS , two three days before i was having a battery alarm in the ac servo so i replaced the battery and the alarm from the servo drive was gone but the machine was not...