Hi,
I know this is an old thread but I have to say AWSOME WORK ! ,You are very talented person.
truckwiz
Type: Posts; User: truckwiz
Hi,
I know this is an old thread but I have to say AWSOME WORK ! ,You are very talented person.
truckwiz
Gerald,
No, there is a inline AC filter right along side the computer box, try pluging the computer into a standard 110 plug in (you will have to do some wiring) ,I'll have to check how much I have...
gerald,
At one time I had a bad ac filter that acted the same way . I do have a extra 386 computer board that I might be willing to sell,lets cross that bridge when you get to it.
Brian
Hi,
Cat 40 tooling, there is a encoder in the spindle belt encloser . The belt is missing that drives the encoder ,but I traced the wiring back to com 1 at the cpu. This machine never had a tool...
Hi,
I have a partner 1 that does not have a tool changer. I am thinking of building a rack at the edge of the table to do a tool change from. How would I get the spindle to stop in the same place...
Hi,
I have a partner 1 that i've had issues with. A bad transformer,cpu filter or bad wiring harness to the X,Y or Z will give you crazey feedback. Try unplugging the cpu from the filter and plug...
Hi,
I'm thinking about building a lathe like this one, how hot would you have to heat up a weldment to destress it from welding it together?
Brian
I've used composite 2x4's and plywood with mixed results , it's made of recyceled plastics.
Brian
Hi,
I just finished up with a 2 week problem with my partner 1 , was getting bad keepboard errors , axis's not moving right , ect.. . Turn's out my x servo cable had a short in it and was messing...
Dave,
Received book , helps out a ton !
Thanks Brian
Installed new glentech boards , works AWSOME ! Thanks for the help
Brian
Hi,
Looking for a partner 1 programing manual , any suggestions ?
Brian
Hi,
Driver from ebay look's like it was in a fire , couldn't get any kind of answer out of www.cncpartsdept.com . I orderd drivers from from Milltronics (I love there tech support , If I could...
Mark,
nice looking drives , I'm going to call him monday to see how much to change it over.
Brian
Hi,
Ya , dave1 had 3 boards but my machine was one of the rare ones that had IMS corp drivers. I found one on ebay and should have it monday . I'll let you know if it works out.
Brian
Hi dave ,
It's one of the boards in the lower right corner, My are green .
Brian
Hi,
I'm looking for a axis controller board for a partner 1 mill, Millltronics says the one I have is obsulete.
Thank's
Brian
Hi,
Here's a dxf I did for Parallax's propeller hat (use a 1/8 ball mill).