I have a fanuc omd with alpha drives. Trying to ad a full 4th. Looking for a drive that would integrate. Thanks.
Type: Posts; User: lowcountrycamo
I have a fanuc omd with alpha drives. Trying to ad a full 4th. Looking for a drive that would integrate. Thanks.
That is a machine tool builder alarm. You probably wont find that in a fanuc book. What machine is this? Do you have a electrical manual? This is usually because an interlock is not open, or tool...
Doing some more searching I found this manual https://jamet.com/Fanuc_Web_Manuals/Drives_Legacy/65002e.pdf is seems that before alpha and beta motors and drives there where the digital ac servos. ...
I posted this in the servo and drives forum becuase I did not know a Fanuc spec forum existed.
I found a Tsudakoma RN150 rotary with no motor. My goal is a full 4th. Machine runs alpha A06b-6079...
I came across a deal on a Tsudakoma RN150 rotary with no motor. My goal is a full 4th, not just indexing. My machine runs alpha drives A06b-6079 drives. I read I can integrate Beta drives and...
I have some play in my bearings and I need to remove the cartridge to have a look. Also, how would one go about replacing the belt. Can't find any maintance manual anywhere.
thanks,
steve
The caps should be of the 370V or 440V variety. I believe 6 awg wire should be enough but if the wire gets hot that is s sign that you need to go bigger. Is you 20hp RPC a self starting or a pony...
Guhl, yes I found that late last night. Over current. I read that usually occurs while in use but I was just powering up. I will check the input on the psm. My buck boost should be here this week....
I just got this machine hooked up to power using RPC with balance V at 241,244,245 with no load. Just powered up the machine and homed and had over travel alarms. Repowered to work through those...
I am looking for fanuc B 65045E .pdf ac servo spindle maintenance manual. I am getting 409 - 30, 414,424,434 alarms. 01 on the PSM. My email [email protected]. Thanks a million.
I just built a RPC for this new to me VMC. I know I should not connect the wild leg to the control but how to find which leg (R,S,T) that should be. I have some manuals but there seems to be a...
I have read that hardinge bought the yang factory and used the same basic machine. They look much alike but not same quality I am sure. I am new to cnc but not machining. This is my first...