Search:

Assuming that is the rear of a Bridgeport type turret mill…there were a couple of attachments that fitted. 1) a slotting head 2) a cherrying head which cuts woodruff key slots. I think those are the...

I assume you are referring to an interact?
If so, the quill is driven down with a pair of ballscrews, I wonder if one ballscrew is worn, and pressing unevenly on the quill?
Some engineers blue...

More seriously , when you mention inverter did you mean the spindle drive?
Do you have a real 3 phase supply or are you using a converter to get 3P from a single phase supply?

I had a problem with one of my machines humming once.
I asked an engineer what to do about it, and he said he would install some lyrics.
He did that, and it sings all day now.
:-)

Hi all
Anyone out there give me some guidance getting going with an earlier version of edgecam. I think it's version 11.75.
I have never used it, so need the post processor sorting, and help with...

Oops, yes Gus you're right thank you. I just checked on my machine and you press the MOD key to scroll through the options until "code=" is displayed.

Sorry folks I was trying to work from memory.

Hi Marcus
Use the cursor arrows to scroll past the user parameters listing until you get to "code =" then using the keypad enter 95148 and press ENT. That should get you into the parameter...

Hi Gus
Success, the parameter to change the language from German to English is parameter 92, and it is set to 2 for English. Phew!
Also I discovered the spindle would not start with a "machine...

Gus,

Story is, I bought machine from a dealer with a tnc155 control with graphics. I told dealer I needed a machine I could dripfeed, they told me I needed a tnc151 control fitted which they...

Ok thanks Gus.

It seems what I did wrong was not entering ALL the parameters. This is because the parameter list I have is from a tnc151 control, BUT, it only has 236 parameters in my list. It...

Hi All,
my TNC151 lost all parameters when its powersupply board failed.
Now the board is repaired, but...........

The TNC151 (now re-installed in machine) powers up in German language.
I can...

Hi all
Interact 4 mk2 with TNC151

Power supply fault caused parameter loss, and control now fixed.
However, it is now in German language.
Anyone have the correct parameters?
What do I do to...

Hi All,
could anyone please answer these questions:

1) With the interact 4 are the parameters for the machine the same regardless of which TNC is fitted.
Or does each TNC (151,155,2500) have...