Search:

I already have a 60 watt CO2 laser System, Thanks. I am looking for a product that will permanently transfer white ink/Coating via laser to a powder coated part.

Looking for a white co2 laser marking ink that will work on powder coat for engraving. Only thing I have been able to find is this stuff from Argentina Color Engraving for Paint .

Thanks, but there is no cut chart for what we are doing.
As a suggestion I'd like to see Hypertherm refine their aluminum processes for thinner materials. We have much better cut quality using our...

Jim Colt,

While ordering some consumables today I noticed that the 220755 cap is Counter-Clockwise and the 220756 cap is Clockwise. We have a custom 45 amp N2 and 80 amp N2 process for aluminum...

To update, the issue was the bottle of gas we received. I purchased a new mix of "F5" and had a much better cut.

270470270472270474

I found this info on our bottle of F5, looks to be correct...

#threadjack lol I never mentioned true hole, I just want to cut with F5 and not have issues...

HPR130XD, Autogas console, Edge Pro Controller, Pronest 2015 version 11.0.5.5518. We are using genuine Hypertherm consumables we purchased through Machitech. We have a dedicated drawer system with...

269366269368

I'd have to find the invoice for the exact amount but I remember it was a little over $100 (came from California, we are in Arizona), we originally had ordered H35 with the thought that we could use...

Ground is good, we can cut the same part on the same sheet with N2/N2 factory settings with no issues. We cut thin stainless with the with the water at the bottom of the plate and it is a auto gas...

Consumables are correct, gas pressures are correct, air is dry...

We got a Machitech Diamond Cut water table with the HPR130xd last May. We finally got our bottle of F5 from our Vern Lewis guy a couple months ago, apparently it had to shipped in from California....

We have a HPR130XD and recently ordered a bottle of H35 to try on some stainless stuff, but they messed up and sent a mix of 35% Hydrogen 65% Nitrogen. Not sure if I want to even bother trying to cut...