Search:

HI THERE CAN ANYBODY HELP ME

MY MACHINE WILL HOME THE X AND Y AXIS BUT I RECENTLY PUT A SWITCH ON THE TOP OF Z AXIS AND IT WILL NOT HOME, WONT DO ANYTHING AND THEY ARE ALL WIRED THE THE SAME THE...

Last night I was working on my machine and everything worked well, this morning I turned everything on and it seems I have no communication to my breakout board, which is a sound logic supplied by...

Hello AJ

I think I have everything figured out I'm running direct drive on the y-axis and 3-1 planetary gear heads on the x-axis on the gantry.

I got a pretty good deal on the gearheads,...

Gary

I can't thank you enough for that little tidbit of information, I don't think I ever would've figured that one out and I don't think I've seen anything in the manual that would lead me to it....

Hello NEED HELP PLEASE (sorry if i posted this in wrong place)

I am running a licensed version of mach 3 for my plasma cutting table, I am using the THC301 torch height controller, and...

Hello I could use some advice from the pros

I am building my first plasma cutting table, and the gantry ended up being pretty heavy I would say about 160 pounds, I am pushing it with Nema 34...

Hello

back again for more advice, I am doing my first CNC plasma table build and need a little help with rack and pinion gear ratios.

My intentions were to run stepper motors direct drive,...

I will get back into the manual

Thanks

There is a box on the left side of the screen that says( layers) on it, and zero when I unchecked the box the drawing disappears when I checked the box it comes back.

Under tools I have chosen plasma, and filled in all the specs as far as kerf width, feed rate, Pierce delay, and so on and so forth.

Under options in the basic settings, in the box that says...

To the best of my knowledge I've specified the tools??

Hello
I am new to CNC, and new to using these forums, I hope I am posting this in the right place, and I hope if anybody responds I can find their replies.

I am building a plasma cutter, I have...