Hello again. I have very good news. The machine is already working. That gives a small problem, which is that in MDI mode you can't run anything, but I hope to be able to solve it soon.
To sum up,...
Type: Posts; User: victormegon
Hello again. I have very good news. The machine is already working. That gives a small problem, which is that in MDI mode you can't run anything, but I hope to be able to solve it soon.
To sum up,...
Hello again. I have very good news. The machine is already working. That gives a small problem, which is that in MDI mode you can't run anything, but I hope to be able to solve it soon.
In the end, we couldn't enter the parameters because it's impossible to write them. The manufacturer has sent instructions to enter the parameters as we are doing and you can't. The G122.3 parameter...
Hello.
I found this thread in another forum where it talks about a "lock key" in "operator panel" but I don't quite understand where it can be.
"reloading Hardinge vmc1000II/Fanuc omd pmc data"...
That photo of parameter 122 is after a "RESET" + "DELT" + POWER ON. Even then, it doesn't let you manually edit the Diagnostics parameters. Tomorrow I'll re-enter the 900 and send the general...
Ok tomorrow I'll look at it. The problem is that it can't be modified. When you talk about 122.3 to 0 would it be 122=00001000 for example? Does that 1 have to be 0?
What is true is that in the manufacturer's parameters, the number 380 comes with a value, which blocks the writing of parameters if you put the value that comes from the factory.
380 = 00010000...
The parameters contained in the diagnostic file sent by the manufacturer are as follows:
N10300 P 00010100
N10301 P 00000000
N10302 P 01101011
N10303 P 00101011
N10304 P 00000011
N10305 P...
Hello.
I have just reset the control again ("RESET" + "DELET" + POWER ON) and I have changed the option "ISO" = 1 and PWE = 1 (although it was already like this) and the following data appear on the...
Good morning.
We have a vertical mill center of the brand Maximart VMC-105E (Taiwan).
Last Monday 22-04-2024 there was an unexpected power outage and when the machine was turned on again, the...
Buenos días.
Tengo el mismo problema que tu con una maquina igual. Conseguiste los parámetros para introducirlos?
Good morning.
I have the same problem as you do with a machine just like that. Did...
Hola. Me he tomado la libertad de coger tu postprocesador "LEKOD_HEID_4AXIS.PST" y hacerle las modificaciones necesarias para poder usarlo en un control Heidenhain con cambiador tipo random y cuarto...