i have an Okuma Mx50 U100m
when i give it an m code (T2M6) i get alarm 15609 ready station spindle LS is not on. anyone know what this problem is.
thanks
Type: Posts; User: FCI
i have an Okuma Mx50 U100m
when i give it an m code (T2M6) i get alarm 15609 ready station spindle LS is not on. anyone know what this problem is.
thanks
I am using an Omron PLC C60k (I know, but I like them).
I have some outputs that are staying dark the line goes high up to the output but the output never changes. no matter what i do it will not...
I have a Toyoda GT-42
I keep getting a coincidence x1,z1 Ex07.
I can reset it and run some more than i get it again.
I cannot find anything on what would cause this, does any one know what it is?...
it has the main memory card, and 2 mb1 cards. on the main memory card there is a daughter board screwed on to it. the machine was running fine. then it sat for a few months and now has this error. I...
I have an LU25 w/ 7000 controller.
I am getting
343-DMA Transfer Error 4 Memory Disk
I cannot figure this one out. I have swapped out the memory card. Ive reloaded the software without error....
I don't get errors going to most types ( I tried others) but going to SA1/RA1 I get that error.
could I send you my ladder and you try to convert it?
need some help.
I have a Fuji FS4 21-t
it lost the ladder, I didn't have a backup (we got the machine used and it wasn't on there). but I had a print out. so I retyped it all in with Fanuc...
I would like to change some of my failing CRT's to LCD's does anyone know of a board or what I need to do to convert these over.
Thanks,
Matt
I have several machines that the floopy drives are ba or going bad. Does anyone know what needs to be done to a standard floppy drive to get it to work with the okuma machines like the LU100 or 7000....
I have several LU15's that the CRT's are going out on them. I would like to convert them over so that I could use a standard vga screen. Has anyone done this before.
I have some CGA to VGA...