Dear Leblondmakino
Can you help me in resolving the alarms of MICON 8 PLC.
Type: Posts; User: Abdullah
Dear Leblondmakino
Can you help me in resolving the alarms of MICON 8 PLC.
Hello john
i still have problem with my lathe machine its in same condition. still have alarm of HALT and INTEL on MICON 8 PLC due to which doent turn in to ready position. can you help me plzz
Dear willydke
i check the turret of my lathe. every thing is fine only Micon 8 PLC has alarm of HALT and INTEL due to which machine doesn't turns in to ready position.
dear DAN
i have HITACHI SEIKI 4NE-2.I also have problem in my MICON 8 PLC. it shows HATL AND INTEL alarm. machine show not ready on CRT even i release emergency. i need your help plzzzzzzzzzzzzzz...
hi buddy
my machne is HITACHI SEIKI 4NE-2.i have problem in my MICON 8 PLC he show HLAT and INTEL alarm. what does it means? can anybody help me !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
i think my machine had micon 8-1. can you plz told me about the diffenerce between micon 8-1 and micon 8-2
dear brother,
i also had hitachi seiki 4ne2-600 with fanuc system 6t-b i need its maintenance manual. if u had plzzzzzzzzzzzzzzzz give this manual
dear brother,
i need the maintince manual of fanuc 6t-b. my machine hitachi seiki 4ne3-600
had spindle problem its micon 8 PLC didnt generate proper voltage i need book to remove this fault
i had found the problem in micon 8 PLC in my machine. some plzzzzzzzzzzz provide my maintance manual of hitachi seiki 4ne2-600.
its high gear commad is m41 i had found the problem in its PLC micon 8 it didnt generate the voltages. some one provides me hitachi seiki 4ne2 maintince manual.
hi i had a machine hitachi seiki 4 NE-2 with fanuc system 6t i had a problem with spindle its rpm are too low a gave him a command to run 3000 rpms but it runs only 300 rpms. plz help me sirrrrrr
hi Hitachi Man,
I had hitachi seiki 4NE-2. my machine had a problem with spindle its rpm is too low i gave him a command to run 3000 rpms but its runs only 300 rpm.
How can i solved this problem?...
i have hatachi seiki 4NE-2 i had a problem with spindle my spindle rpms are too low. i gave him the command to run 3000 rpm but machine runs only 300 rpms