Search:

A 5hp converter would be way too small to run this welder. A 5hp would produce around 15 amp of cuurent at 230v. That would probably not even start the welder and if it did would not allow for much...

pinguS

Have you had any luck using the G70 command for finishing? I have spent numerous hours on getting this to work to no avail. The biggest problem I have run into is that the G71 command is...

I am not one to get a on a forum and bash, but I have read this thread from the start. Way back when I purchased a version (I believe it was V17) with the promise that it would post to an older...

Could somebody be so kind as to email me manuals for my Fanuc 0T-A? I have them in book form but hate to keep getting them dirty on the floor when I need to use them and have always wanted these in...