Search:

To clarify, I believe you can get quality stepper drivers from China as we speak. And I'm not just talking about the Leadshine DSP-based ones that cost as much as Geckos.

Disclaimer: while I...

As a follow-on to this...I think it's important to note that you CAN get quality devices made in China. Perhaps not a popular point here, but still, valid. The TB6560-based drivers obviously don't...

Just swapped in the CNC4PC model C1G break-out board. I dialed the pulse width all the way down to 1.5 microsecond. The steppers responded as they should -- no missed steps :)

Now, I need to...

I'll admit -- I was lazy, and ordered a different breakout board (CNC4PC model C1G). Basically, though, you could use the Wantai BOB if you took the inputs of the optocouplers and used those as the...

I've hooked up all three drivers to their stepper motors, and after solving a number of issues, have gotten them running.

By the way, Longs Motors (Google Maps has them located about a block away...

Thanks, Moosecat. I saw the spec sheet for the m860m, but the current output settings diverged from those of the dq860ma more than the m880a.

I'll be hooking these things up for experimentation...

I've seen a few posts regarding the Wantai (Changzhou Wantai Electrical Appliance Co. Ltd.) DQ860MA stepper drivers, asking about wiring and such. They're part of some of the stepper motor kits...

I'm arriving late to this thread, but since I just bought some of these from Wantai and have been doing some research, I thought I'd share what I found, in case it's useful to others.

I believe...

I'm deleting this RFQ - I believe the threads are close enough to 15/32 - 32 (in fact, they might be just that) that a tap with those specs will do the job.