Thanks that worked :banana:
velocity 105 and acceleration 11
Turned out prefect.
Type: Posts; User: Iamwoodnut
Thanks that worked :banana:
velocity 105 and acceleration 11
Turned out prefect.
Ahh, newbie mistake.
Question, does the velocity and acceleration have to be the same for both x and y axis?
My current velocity is 150 in/min and acceleration is 22 in/sec for all axis.
Thanks Jeff I will try this.
The feed rate by default was 10% and I raised it to 50%, will lower it back down and try again.
It funny how it loses steps in the same place every time.
Ok this is the second time this has happen.
This time right in the middle of cutting the "M" the x axis loses (don't know how else to describe it) 3/8" ??!!
The file was made in Artcam and save to...
Well so far its just seems to be this file that is acting up. Don't have a clue why.
Will try and redo the gcode for it and see what happens. Tried 3 other files tonight and all worked OK.
OK I am really scrachin my head big time on this.
I got my new motor and driver, all installed with no problems. Still a bit of fine tuning needed but it close for now.
My NEW problem is on the X...
Thanks guys,
Looks like I will be ordering another motor and driver to solve the problem.
Any tricks to fine tuning a slaved axis?
I am having a problem fine tuning my Y axis.
I just change it to rack and pinion and, after a bit of head scratching figured out the steps per inch. I had it running underneath before with a lead...
Yes I can access the link no problem,
Thanks.
Thanks Ger21 this worked!!
:cheers:
Hi All
I am having a small issue with some code I added to this script.
The code works fine, slowly lowers the Z till it touches my probe and retracts back up. But my probe is fairly thick...