Thanks James. You've provided me with a lot of good info in these last couple of posts. I think my lack of knowledge and inexperience is showing through:rolleyes:
Type: Posts; User: shopteacher
Thanks James. You've provided me with a lot of good info in these last couple of posts. I think my lack of knowledge and inexperience is showing through:rolleyes:
The table will be a wood router in a home shop. I don't think there would be much in the noise source area, but I could surly be wrong.
Another question: If I use 2 motors to run the gantry back...
I ordered a power supply from Antek yesterday and it's just about exactly what H500 said.
Power 800W
Output Voltage 50V current 16.0A
Now my big dilemma is for a board. I seem to have narrowed...
I think I'm starting to understand. Another question. The gecko's are rated at 7 amp max. Does that mean that no more than 7 amp can be drawn on the drive or that no more than 7 amp can be connected...
Thanks for the input. The whole electronic side of the machine is where I fall short on knowledge, but I've gained a good bit from this forum and I believe I have a general idea of how the...
I have a question about the voltage form a power supply and the stepper motor. I've searched the forum and got some hits that seem to pertain to my question, but my electronic skills are limited and...
What would it take to upgrade a digital tool router to todays standards? Like to use alphacam, mastercam or similar software?:banana: