Thank You Doorknob .
I will call Gecko on Tuesday . I am just very frustrating , I wish and willing to pay a little bit more money so I don't have to go through this debug hell .
I am making...
Type: Posts; User: PleaseHelp
Thank You Doorknob .
I will call Gecko on Tuesday . I am just very frustrating , I wish and willing to pay a little bit more money so I don't have to go through this debug hell .
I am making...
My Volmeter is set to DC
It is the same for X Y Z Axis
I use a volt metter , put Neg on -B (pin7) , put Pos on +B pin 6 .
The volt metter show 2.2 V
Yes the motor run , Yes it is working but it is fair to have a silence motor when it is idle...
I put my new 10000uf across pin 12 and pin 11 .
The hum sound from my step motor is still lound and clear . Pin 6& Pin 7 of my DB9 is still 2.2 V
:( . Anybody has any ideas ???????
I went to Frys Electronic and purchased a 10000uf capacitor .
I will put it accross my -V and my +V . Hope it would get rid of the motor hum .
I will post the result tomorrow
Orin called and He sugested I Ground my computer, my power supply and my G540 .
I went ouside put a piece of metal to ground and run the wire to my computer chasis , connect with db9 shield and...
Anybody in southern California , If you know the solution : please call me at 1-323-770-1598.
Thank You
You ask for it :
- Redesign the G540 by imagine you are the user , How would do you feel to do the soldering for DB9 with a resistor . Don't design something that any user would curse at the...
Just got my G540 2 days ago.
I try the following Setup :
- No DB25 connection .
- Pin 11&12 > 24V DC
- Pin 10&12 EStop