I am able to allow the controller to figure out my P word for threading. However, I then have to manually enter the numbers into the program from my macro variable. Since the P word cannot contain...
Type: Posts; User: homchz
I am able to allow the controller to figure out my P word for threading. However, I then have to manually enter the numbers into the program from my macro variable. Since the P word cannot contain...
Fanuc Motor: A06B-0751-B100#3000
For the past month I have been seeing an AL-31 from my spindle motor. Some weeks there is no issue what so ever, others it will trip out any time the spindle...
The machine has run fine for the last month we have had it (bought used). We set the cold start and home in the same position for ease of use.
Today the machine seems to want to find CS anywhere...
I have been chasing this issue for at least a month now.
I have a Fanuc 18M Control on a Grinder. My first issue was a 414 error on the Y axis. Long story short after talking with Fanuc:
First...
I have tried other places might as well try here too. Our shop recently aquired a Kikinda 12x40 surface grinder URB-1000-A, and I am looking for manuals or schematics. Figured maybe someone here has...
Needing to remove the quill on a 325, I mistakenly unscrewed the ball screw. It is rebuildable but not cost effective against a new one. I can get one from 3SInc, but was wondering if anyone here had...
Thanks for the info, A-2 sounds right but I would have to look at the job slip to be sure. To save time and the fact we were only taking a small amount off the part we ended up surface grinding the...
My Tree 325 Journeyman seems a tad underpowered.
The other day I was working with Annealed plates about .500 thick and needed to mill them down to .420. The plate is about 4" wide and 18" long....
I have a connection that works on a Fanuc Control, but not the Delta Dynapath 20.
We are using Easy Talk for out program.
Right now we have settings at
BAUD: 2400
DATA Type: ASCII...