Search:

Hi,

Should the code be from X-5.75. to X+5.75 while catering to the diameter ?

(I have no knowledge in CNC Lathe )

Can you let me know the software being used to generate the G-Code ?
...

Hello,

Thanks for the G-Code. Can you re-send the same suitable for diameter of 11.5 mm as the CNC Lathe operator accepts diameter only and does not know how to key in radius.

Thanks in advance.

Hi,

Sorry, I was not clear in my post. Your G-Code is correct but there is a little modification required. The movement in the -Z axis is 10 mm and +X axis is 5.75 mm. When I plot your G-Code, the...

Hi,

I used the G-Code in the software. The Ellipse curve is fine but there is one final issue - The Ellipse section is reverse. It needs to be rotated by 180 degrees (Clockwise). Can you do me one...

Hi,

When I open the G-Code in jviewer or SketchNC, I am seeing the following instead of a curved line

264068
264070

Is this ok or is some post processing required on the G-Code ?

Thanks...

Hi,

Thanks for the reply. I am specifically looking for X, Z, I , K value type of stuff. Secondly, can you recompute the values ? The total height of the ellipse is 11.5 mm and width is 20 mm. The...

Greetings!

I badly need help for generating G codes(G03) for a CNC 2-axis lathe for turning a ellipse out of a rod. The Rod dia is 12 mm and the ellipse (Full Ellipse) size is 11.5 mm height and...