Search:

If you mean "Problem with Z axis binding", then it is all about alignment - from end to end. You need to make the appropriate adjustments to each end. I have had mine off and on a few times and it...

I had the same issue with my X2/Large Table CNC Conversion project. The large base is a lot beefier than the X2 base. I cut a pocket in the large base and gave the ball screw plenty of room. ...

Sounds like your Z axis ball screw is out of alignment and binding. I would give a go at aligning it end to end.

Same parts here. I found that your focus when assembling the Z ball screw should be totally on getting the screw straight and parallel - don't worry about the various "pieces" aligning with other...

Yep, looking for the leadscrew - I will look for your update on it!

Thanks!
Paul

Hi aarongough,

If it's not too much trouble, would you mind posting some of the details of your Hand Wheel / lead screw mod? I am interested in doing something similar, so I would like to know...

Thanks Hoss!

That's interesting! This is the response I got when I asked about the conversion this week:

"sorry, but our kit does not fit the LMS large table assemble
properly. We had one...

Hi!

I have a Grizzly Mini Mill and I would like to upgrade to the LMS Large table with CNC on all axes. I have contacted CNCFusion and they say they don't have a kit that will work with the Large...

!

One thing I am hesitant about with the CNC Fusion is the Z-Axis. I have seen at least one solution here that I felt was a lot better. Problem is, I need to re-research - I have been out of touch...

Yes, I have though about doing the same - but not sure it's necessary to go through that - I'm not THAT good either - meaning I'm not sure I could do any better than CNC Fusion!!

What's your...

I am finally considering getting into converting my X2 to CNC. I have had it for several years and always wanted to do it - been lurking here for some time!

Other than choosing the 540, I planned...

I don't understand why no Mod has answered you!!

Yes, it can certainly be used for one!

A couple more questions!

What size motors / power supply did you go with?

Did the kit come with the motor couplings?

Thanks again!
Paul

I am getting ready to do the same on my Grizz.

Where did you purchase the "G540 3 Axis Kit" from?

Are you pretty satisfied with the CNCFusion kit?

Thanks,
Paul