Correct. What I would like is for G116.1 to *not* turn on if X008.7 (SKIP input) is turned on. Since X008.7 is wired directly to G116.1, it looks like I can't disable it using a diagnostic bit. To...
Type: Posts; User: EspressoE
Correct. What I would like is for G116.1 to *not* turn on if X008.7 (SKIP input) is turned on. Since X008.7 is wired directly to G116.1, it looks like I can't disable it using a diagnostic bit. To...
Here's the whole image (quality is horrible, sorry about that). I will get a new picture today. Maybe I'm misreading the ladder? I was thinking that because the first line shows X008.7 <-->...
Unfortunately, there is no D-bit between X008.7 and G116.1, so I'm stuck with either trying to modify the ladder or upgrading the whole control system (which also means that I need to replace all of...
I didn't realize that the PMC-L was built-in to the memory card -- that helps clear up my confusion immensely! Thank you! The ladder is visible, so no problems there. I'll look for the 0e1 and 0e2...
Thanks for the reply. The SKIP input is actually working on this machine, so if I can modify the ladder, I should be able to use it.
N001 (move X +100 mm and then Y +100mm, if skip input is...
My machine has the X008.7 SKIP1 input on the same pin as Single Block mode (SBK.S), so if I try to use G31, it works correctly, but then I have to hit the start cycle to have the machine continue...
Finally got a chance to try this today and using DPRNT from a program does work fine, so it appears that 0-MD can't be drip fed via DNC and output status using DPRNT at the same time (or I haven't...
I have the red-cap motors as well. I cleaned up the connectors and still had the same problem and then gave your P + Cancel on boot-up a try, re-homed, and now everything is fine! Turns out it only...
I haven't tried P + Cancel during power-on since I understood that just disables the soft-overtravel alarm on power-up and just applies to absolute encoders. This machine doesn't have absolute...
I have a Faunc 0-MD Mill (Lilian CNC 400) that was just starting a milling cycle and during the G53 Z0., the Z-axis halted suddenly and an alarm 339 Alarm for the Z-Axis SPC was generated. I power...
Thanks for the reply. When the customers use this feature for machine monitoring, are they drip feeding or running programs from memory? The M74 connector is not used, I've heard that I may be able...
I'm trying to use DPRNT in DNC mode on a Fanuc 0-MD machine over I/0 0 (M5 connector) for status and probe position output, but I only the initial DC2 is sent and then the machine quits responding...