Search:

Pulled the front cover and you guys were correct the belt was very loose. I'm guessing it was bumped hard enough in shipping that it shifted. I tightened it till the belt was "snug". Fired the...

Thank you sir, I was hoping it would be that easy. How tight should it be.. I would think to tight would be hard on bearings

Is this a standard belt that I can get anywhere or a special order mori part. If it's standard what's the size. Is there a way to tighten the belt on these machines.

Thanks for the help

I finally got this machine up and running on all 4 axis. I've run numerous programs with small tooling in aluminum and mild steel. I started a new part that's made of annealed 316L and it basically...

If you program any degree in any direction it runs short of the actual angle. It thinks there is 392 degrees in a rotation..

Our new to us MV-Jr with fanuc 10m controller doesn't go to 45 degrees if you program it to do so. It's about 34 degrees. I think there is a parameter that is not set correctly. It's like the machine...

I was deleting program files on my MV-JR (new to me machine)and accidentally pressed "All" and erased all programs including my tool change sub program O9001 I think.
If anyone can post what this...

I was deleting program files on my MV-JR (new to me machine)and accidentally pressed "All" and erased all programs including my tool change sub program.
If anyone can post what this program should...

Thanks, we have another phase converter to run on so we will switch it off this one. We really didn't realize that it was that hot its a factor built converter. Is there anyway to fix the output of...

We are running this machine off a phase converter that is putting out 249 volts evenly. And we are getting Ot108 24 volt to high alarm. I think I've fixed that. The spindle drive board has a switch...

One more question. Does anyone know the homing procedures for homing the 4th axis. I think it needs to be turned on in the IPL menu but I don't know how and I didn't get any manuals with this machine

Thank you very much. I really do appreciate the help from both of you.

I don't know if this will fix my problem.. I can home the Z and Y axis with no problems. But when I send the x axis it runs down till it sees the decel bracket and then slows to its "homing speed" it...

Please break this down for me. I understand with no soft limit switches I won't get an alarm but that doesn't fix the homing part. The machine goes past where it thinks machine zero Is before it...

Hey guys been lurking here for a while now. And even though I've run and programmed CNCs for several yrs. Its also been a couple yrs since I've done it.
With that said I just puchaced a MV-JR with...

Hey guys been lurking here for a while now. And even though I've run and programmed CNCs for several yrs. Its also been a couple yrs since I've done it.
With that said I just puchaced a MV-JR with...