Hi all,
I've come across a rather strange problem.
As I post the code for a Z level finish with multiple depth steps the program doesn't post the plunge feed rate when moving down from 1 depth to...
Type: Posts; User: primotechnics
Hi all,
I've come across a rather strange problem.
As I post the code for a Z level finish with multiple depth steps the program doesn't post the plunge feed rate when moving down from 1 depth to...
Sean,
That would be fantastic!!
Thanks for helping!!
Gr
Bart
Mike8 and SeanDa,
Thanks for thinking and trying to get my BobCAD even better!!
As Mike8 describes is about wright, I need to be able to select a location in the ATC without that having any...
Sean,
Thanks for the reply!
The numbers are not ralated to tool diameter.
What I want is that I can assign a tool position in my tool changer and the offsets (D and H altough I only use D) stay...
Hi,
I've been having the same issue for while, see here ? Bekijk onderwerp - Siemens 810M GA1 geheugen uitbereiding
Maybe this helps?
Gr
Bart
Hi,
Which controller is it?
Mine has a 810M controller which has a button which need to be pressed and then you can Jog the axe which has overtravelled away from the switches.
In my case that's...
Rob,
You're too kind, I know why he is doing that and thanks to you I've found a solution!!!
First, why I'm getting the decimal point: My D numbers in my PP are generated by the tool_length...
Mike,
Thank you for giving your thoughts on the matter but I wanna try to make it as crash proof as I can, and doing it manually is always a risk.
I do it manually now, but I've come as far as...
Rob,
Thanks again for thinking along!!!!
I've seen line 267 in the PP but unless I'm missing something here, it only gives you 12 numbers albeit different from the ones in the ATC.
I can add,...
Rob,
Thanks for the reply, really appreciate that!!
I was probably explaining myself wrong here, so I'll try to clear some things out.
I use a different offset (H or in my case D) then the place...
Hi all,
Since I've been breaking my head on this one, hopefully someone can help me out:
I'm using V27 and have the tool crib all set up with all the tools I have.
For posting I usually have...
Hi,
I have the same machine (and software) and also VERY interested if someone can/will give an answer to the question, how do I get more memory space?
I found out at the time the machine was...
Beware if you go to the initial clear mode, if you erase to much you need to reload TEA1, TEA2 and PCP files. Make sure you have them.
In official Siemens book error 12 states:
-Error in RAM area...
No problem,
I've had a simular problem on mine in the past and it turned out I needed Step5 to upload all the files.
I tried several times to upload, even do it manually but without succes, in the...
Hi,
You're getting close indeed.
MD2001 is for the first Axis and 2002 for the second one.
You can also determine the increments, that may cause the problem too.
In these you tell the machine...
The 1st alarm is the problem causing the others to show I think.
The UMS is the memory which (can) contain all backup and machine data. Since alarm 1 tells there is a indentifier problem I reckon...
Hi all,
I have a Chiron FZ12W in the shop and missing memory to be used.
Since I bought the machine second hand I have no idea of what the memory should be
I did found a found a memory module...
Hi,
I'm not an expert but I think you have a deeper problem.
The ORD number means the order in which the alarms pop up.
In your case ORD1 is the mean problem I think, the UMS memory is missing...