Hi, Thanks for your post.
I have used Bob Cam/Cad with Post Processor for Mach 3 and it works fine.
I'm not sure what you mean by "output which you want from Sheet cam" ?
Thanks Marts
Type: Posts; User: Marts
Hi, Thanks for your post.
I have used Bob Cam/Cad with Post Processor for Mach 3 and it works fine.
I'm not sure what you mean by "output which you want from Sheet cam" ?
Thanks Marts
298670
This is the settings page from which I set the 1 to 7 values.
Marts
I have established that the speed is set purely by selecting one of the 1 to 7 values in the hand held control, whatever the G code in the program is. it has no influx on the speed
I would very...
Hi Xjdubber,
You are correct, firstly I was holding the tacho far too close to the spindle, now I'm getting readings that are realistic, I have also set up the spindle as per the user manual...
Hi Xjdubber
I checked the speed with an optical tacho, it was originally running at 3600RPM which for an engraving bit is far too slow as you rightly stated, 9K would be better.
Yes it has a...
I have acquired a XYZ tech 3030 CNC engraving machine which I have so far run a few programs, however I'm having problems with getting the spindle speed set, I input the speed within the program M3...
I'm trying to get a small engraving machine running for a friend but I don't have the correct Post Processor. Can anyone help!!
I believe G-Code Arcs (mm) (*.tap) works but I don't it, plus I'm...
Thanks guy's, I have removed the driver etc. from the PC for the old Parallel card and made the new one assigned to LPT1 as in the mach3 software. I have checked continuity between both end of the...
I have an older X4 plus which has suddenly stopped responding to the PC, it runs in manual without a problem.
The problem started when in manual the Z axis began to refuse to travel in an upwards...
Just looking around at what may be available in bench cnc lathes.
What would a reasonable price be for a Hercus Computurn?
How do they compare with the Emco Compacy 5 CNC?
Martin