Search:

Hey Everyone.

Been on here a while but mostly with CNC Mill/Router building etc.,

NOW I have myself a CNC Lathe that I am almost done getting put together.. I want to design and cut Trim...

Hey Everyone.

I purchased a set of 4 NEMA 42's from Automation Technologies and a breakout board from China.

I am trying to figure out how to wire it up to the drivers. I can't figure out...

Hey Everyone.. I am making a 24x36 cnc router / mill.

I want to try and make a quick change tool / collet setup so I can set my tools up before I do a run then just change them out as needed.... ...

Hey Everyone. I am looking for some help with getting my Makers Stamp drawn up so I can have it milled in O1 Tool steel so I can use it on my knives I am making. I don't have experience in...

Helllo Everyone,

I am looking to having same drawings made so I can have a part routered out of wood.

It will all be done on one side. There is some rounding needed, etc.

Please email me at...

Hmmmmm. Why not weld to the shaft and turn it tru again on a lthe and then all set. Should I go to a bigger motor as well? say 3hp

Also why would I have to change gear controls etc? I though this motor was attached to a pulley and belt. I figured we could mill the pullry to the new shaft and key and bushing if needed...
...

Where did you get your phase converter? Are these expensive?

Hey Everyone!!!

I have the chance to buy a older model Bridgeport mill for a GREAT price. Problem is that the motor on it is rated at 3 phase 575 volt.

I have a little shop that only has...

Hey everyone.. I am planning on making a little rc automobile and i need some 3d drawings done for my cnc mill to cut out the plug so I can vaccume form them.

Anyone up for a little task? All I...

Hey all.. So I am very new to the CNC hobby and I am trying to figure out the best way to draw some parts I want to mill out.. I am almost done my DIY cnc router and I am not good at all yet with...