Search:

Hi Colin,

1) Look for pulse coder signals in Diagnose DGN 713,714,719
2) Check LSI chips MB8739AE(H) and their contacts on motherboard and ADD Axis card if present
3) Check pulse coder feedback...

Hi,
assuming everything is fine at the control side
1) check all wires/connectors on motor again often the solder points look fine but the
cable itself barely holds contact, move all cables....

@memoryman
Please send me a PM.

@Sinumeriko
Hi, your PM Box is full, I tried sending one, and got that info from the board software.
can you pm me your mail address ?

regards

@greenery_fr
Thanks,
I did send you a PM.

Hi,
I did clean the whole pcb, first used air then contact spray, that was on sunday evening.
Result was negative too.

On the right side of the pcb, in the area where the BMU board is,there are...

Hi there,

we (small 2 men metal shop in germany) have a problem with
our wire cut machine (Matra Tape Cut).

Control =fanuc 6mb
main pcb =A16B-1000-0030/06c

Following error's since last...