Search:

Thank you Tom, I'll check that out!

Best,
Justin

Hi Tom,

Thank you for your help, that worked perfectly. With your and Chris's help I've got my machine back almost to where it was. One thing that is happening that wasn't before is that very...

Hi Ben,

Thank you so much for your responses and suggestions. With the help of another member, Chris Perez, I've been able to get my machine mostly working. Basically all I had to do was execute...

Hi Ben,

Still haven't got it back working. I've been reading a lot on this website and on the Dynomotion site. Most of it is over my head right now but I'm slowly learning things and will...

Hi Mark,

Wondering if you have had success getting your machine setup? I am in a similar position to your own though due to my own fault. I have a K2CNC KG2525HD which worked fine for the past...

Hi Ben,

Thanks again for your help. I'll look into that. I did previously attempt to downgrade by refreshing the KFLOP card with the previous version of motion thinking that may magically make...

Hi Ben,
Thanks for responding so quickly. Yes, kmotion 4.29 is still installed in a separate directory from 4.32, however I don't see any of the previous settings there. When I open the 4.29 kmotion...

Hi all I'm hoping you can help!

I've had a K2CNC model KG2525HD for the past year working great with no issues... until I decided to try to get Mach3 to work with it and ended up upgrading the...

Everything is good again :)

OK I think I fixed it. Reinstalled the driver after disabling signature permissions. Computer and control box now say they are connected. I'm going to take them back to the shop and reconnect to the...

I have a K2CNC 25x25. Until yesterday it was working fine with Windows 8.0, KMotion, and kflop. Then I decided to upgrade to Windows 8.1 and now the computer no longer talks to the control box....