Take a look at Vectric VCarve. I use it all the time. Fast easy and cheap. Has never let me down and I have always been able to do what I want with it
.........Ricochet
Sent from my iPad...
Type: Posts; User: ricochet
Take a look at Vectric VCarve. I use it all the time. Fast easy and cheap. Has never let me down and I have always been able to do what I want with it
.........Ricochet
Sent from my iPad...
Hi Tom, This post of Q&A with WT is by far the most informative material I have found for getting started and completing a project with Kflop / Kanalog and Dynomotion.
Thanks for all you do! ...
Ok, it seems that the computer does not use a normal bios or CMOS configuration. Early Hurcos have proprietary Bios Chips. (There isn't even a backup battery) When the system boots up it looks for...
My bmc 20 has not been powered up for almost a month now. I tried to start the machine up and I get an error on the monitor.221574. It appears to me that the bios has lost its memory, maybe the...
What would cause the module to go out? I just got the drive back from repair and never worked. Where can I get a module? Thanks for the reply
...........ricochet
Sent from my iPhone...
Hey Steve, I was wrong, my control is a Ultimate Max 3.
I did slow the feed down. It was set at 400 ipm I set it to 100 ipm. I tried to calibrate the drive and it faulted again. I also checked...
I will take a picture & post it tomorrow
...........ricochet
Sent from my iPhone using Tapatalk
Yes, that is what I have been thinking about all night. For that kind of money I did expect different results.
......... Steve
Sent from my iPad using Tapatalk
Thanks for the Reply. I will check that out also.
......... Steve
Sent from my iPad using Tapatalk
Thanks, I will give that a try in the morning. Have you ever had this problem with your machine?
Sent from my iPad using Tapatalk
It is a Ultimax 2. It has a pendant with it
How do I slow the speed down. This is a new to me machine. I did run the machine befor purchasing it and all was fine. The problem started when I got the machine in our shop. It has never worked...
I keep getting an Encoder Fault and Servo Drive shutdown on my Z Axis when I try to calibrate and home my machine. Is there a way to test what is going on? If so how can I do this. I was thinking...
My Servo drive keeps faulting!
My Z Axis drive faults when I try to move that axis, The drive is a YASKAWA SERVOPACK CACR-SR.
Some times the drive will work when commanded and some times the...
Has anybody ever found an English version of the manual and electrical schematics for this Simoreg 6RA2620
I have one of these drives and motors and need to know how to wire it to my system. Any...