For mechanized systems I go with Kaliburn , for hand helds Thermal Dynamics
I have used both in my shop for years no problems. The nice thing about these machines if you blow out the pilot board or...
Type: Posts; User: BIGCNC
For mechanized systems I go with Kaliburn , for hand helds Thermal Dynamics
I have used both in my shop for years no problems. The nice thing about these machines if you blow out the pilot board or...
A good supplyer for gear rack is axisautomationinc.com they have them in 12'
lengths for $168.00 and $38 for the gears. 20 dgree pa and 24 pitch rack size is 1" face x 1.25 .005 culmlative error...
Fast cam has a Program called FONT GEN check it out all lines are arcs and lines no polylines or splines.
Just a small note to rule out any problems with motion make a small fixture with a pen that will slide up and down use a rubber band to apply pressure
attach the fixture to the torch, Put a flat...
Sounds like electrical noise problem you might have check the servo cable sheilding with a ohm meter and make shure your ground passes a light bulb test .
I am not particualy fond of Hypertherms small units i have used them all over the years
On machines i build i use air cylinders for primary engagement and a small spring to provide tenision when the air is off, so position is not lost. I use a small regulator to set pressure on the...
You Can Get An Sc10 From Thermal Dynamics For About 4600.00 Us Or Camsoft Has The Electronic Part Of The Controler For About 800.00 But As Far As Anything Else Goes You Wind Up In The 10000 To...
I prefer a Thermal Dyanmics 150 xl good strong performance with this machine the automation model can be bought for about $6800.00 US it comes with a water cooled torch and automation hookups built...
See my gallery i will include more later or i give u some in larger format.
The Table Was Built And Machined In My Own Shop From Scratch , The Table On My Machine Is 5'6" By 12'6" , Under The Sikin The Structure Is 4"x4" X.250 Wall Tube . As For Cutting Area 5'6"x10'6" Is...
This Table Can Handle 2" Thick Plate , As For Table Size I Get Into A Lot Of Large Jobs , 5'6" X 10'6" Is The Best Size For A Cutting Table. We Manufacture Cabinets For Mills And Lathes.
You Can Buy Precision Linear Rails For About $1000.00 ,that I Perfer Over Rod Shafts , A 30mm Can Handel 6200 Lb Dynamic Load . Also If Your Gantry Is Single Side Drive (no Slave) Make Shure The...