Search:

How are you attaching the 2 halves together? I am going to be doing this with my Ipod Touch. I plan on resisting shock better with using my Otterbox rubber and plastic case underneath the billet...

Im using a HAAS TM-2 that does not use oil but grease for the ways. Using TRIM C270 but find that 1% less on concentration leaves rust spots on the table, and 1% over recommended concentration,...

How can i figure out how many tons an old press is that i found in the corner of the shop? All the markings are either painted over, or do not make any sense.

It has something with the flywheel...

Has anyone gone from OneCNC to mastercam? or from Mastercam to oneCNC? i want to know your thoughts on how the learning curve was. I have MCX experience but new shop = new software.

Great to hear. I have been debating between BobCAD-CAM and OneCNC or the past week. Looking at so many videos and examples, i'm really thinking that OneCNC is the way to go. Hearing you say its much...

A 3 flute for deep-ish hole drilling. Humm, i never would have thought it had enough flute to evac chips properly. But if you say that you do it, i shal give it a try. :cool:

I've been trying to find this drill with no split point. Still a little confused as to what im looking for.

lesr, thanks for the link. will check it out.

Former Moldmaker getting into production machining. What is the best approach to drilling a 7/16 hole 3.635" deep in 6061 with a CNC that does not have thru spindle?

I know that its going to be a...