Search:

Yeah it helps a lot. Makes programming pretty easy I think. You can do all kids of cool stuff very easily

I have it, PM me.

Call Charmilles, 1-800-282-1336.

Have the same machine, why not just put it on a floppy? These machines are notorious for losing software, I would not leave any programs on the machine.

I have lots of experience on this machine. What kind of material?

What kind of material are you burning? What kind of flushing? Lateral, through the part? Through the workhead? Do you need to pulsate aka "peck?"

Another member helped me out a lot in another section of this forum so I wanted to pay it forward. I see a lot of people asking for IPS programming software for the Roboform generation i.e. Roboform...

OMG I think I just died. I actually did it! Thanks for your patience and time. I have been struggling with these drawings for years. There arent words.

Do you see what I mean, does this look right so far?

Im sorry, I meant I cant move the angle lines to the corners of the inner teeth

Ok got that part now I cant seem to move the line to the snap points. How do you do that?I can pick the line but it wont snap to the end point on the ID tooth. Thanks a ton!

I am stuck on how to make the angles. They never get put on the right orientation with the image. Theyre always going the wrong way!

How did you draw that!
See attached...

Yes I am using wire edm. Brother HS70A

I have had this question before...
http://www.cnczone.com/forums/bobcad-cam/171995-v23-need-help-gear-spline.html

Attached is a drawing I am trying to draw in bobcad v26. With Burrmans video I go...

My gratitude for the YouTube video!

THis is for an actual job. That is a customers print. I am using this to create a wire EDM program for my HS70. Usually we just buy them on the outside and Id like to start making them.

If I managed to make one of these shapes would I be able to easily edit the OD and ID of the teeth as well as their widths? Or would I start fresh every time? I make dies for bolts and nuts and these...

Why would I want to rotate a circle?

What I have done so far is create circles to the outside of the teeth and inside of the teeth. I am stuck because I dont understand what to do next.

I appreciate the reply because no one has but what you said may as well be in Chinese. Haha! Ill give it a try though. I actually dont need those two circles shown, I just need to know how to draw...

The files you are looking for would be the "X" technologies, that will allow you to modify. I have them if you want them. PM me. I dont know any way to look at them on a pc. Only on the machine.

Tool steal will go quick on a RAM edm. I burn that stuff all the time. If you are going .308 deep I would suggest 3-4 burns depending on the reduction. I use a mill to make my electrodes. You can use...

I buy charmilles Deltacut 900+ coated wire. I have done a lot of test cuts and comparisons and that wire is the most bang for your buck. If you want a contact PM me.

Hey guys, first post. I am new to bobcad, had it for a while but am not very savy with drawing. I have a spline that I cant seem to figure out how to draw. The closest thing that bobcad has for a...