There was a corroded leg on the eprom nearest the backup battery, I replaced the leg with a strand of wire and also the tantalum capacitors needed replacing.
Type: Posts; User: GPtech
There was a corroded leg on the eprom nearest the backup battery, I replaced the leg with a strand of wire and also the tantalum capacitors needed replacing.
Just to follow up, I got this lathe running. I repaired the FX784-9 board and also had to replace a servo and spindle drive.
Hi, I hope you can help.
I have just purchased a QT8 that wasn't functioning. When the NC is turned on all I would get are zero's and a blank screen.
I replaced all 3 batteries (they were dead...
Ok, Just wanted to give an update to this.
I received a phone call from a chap in Melbourne, Australia. That had a similar problem to me on a Chavalier VMC with a Fanuc 0mc controller.
He had...
Ok, thanks. I'll give that a go, is the adjustment straight forward?
And it doesn't jump on the Y axis.
Well it jumps whether I use the handle or MDI the .001mm increment and at 100mm/m or 1000mm/m feed rates.
Is this the parameter your thinking of?
Cutting feed and rapid traverse separate...
Hi,
My mori is jumping on the X axis whenever there a value other than 0 in the parameter 535, backlash compensation.
Here's a video of what's happening.
https://youtu.be/7AdIM1ALRJ8
I found the solution to this, member Stucapco scanned some pages from his manual for me and they were different to what my manual had.
Instead of inputting "-1" to cancel the tool number you enter a...
Lots to learn, I made the assumption that the tool offset would be loaded when the tool was loaded, didn't realise I had to also do G43 H#.
Aha, what if I want to delete a tool number? It should let me do that.
I'm working around it by calling up say tool 6 for my 6mm endmill, and the machine knows where it is in the magazine...
Yes it is a Fanuc 0m.
Hi, Yes sorry that post was not clear, I key in 5 input, 5 input, then press the "WRITE" softkey. All I get is the flashing "**MISS SETTING**".
According to the manual -1 should clear the tool. So...
Hi, I have a 1992 MV40b that I'm having trouble setting the tool positions on. When I'm in the tool settings page the manual says to put pot number in MG and tool number under T.
Example MG 5 input,...
Hi everyone, I just picked up a Mori MV40b with the Fanuc MFM4 controller and I was told that it didn't have the rigid tapping option. Is there a way I can check if it has it and if it doesn't can I...
Hi, can you elaborate on why you would buy the candcnc unit over building your own, $750 is a fair chunk of change.
Thanks.