, admin feel free to move to correct place if wrong location
I am trying to figure out which air cylinder to buy for my pneumatic draw bar on my PM45 CNC conversion. I was looking at a fabco 3...
Type: Posts; User: ApexMotorsports
, admin feel free to move to correct place if wrong location
I am trying to figure out which air cylinder to buy for my pneumatic draw bar on my PM45 CNC conversion. I was looking at a fabco 3...
Looking for ball screws in the 25 and 32 mm range, 5mm lead in P4 ground grade that doesn't break the bank. I called thompson for C3 quote and it was 2600 per screw and I just laughed. Then checked...
So I called Thompson to price check C3 grade ball screws or my cnc conersion of my RF45. I would like to make the machine as accurate as I reasonably can. However when the lady told me 2600 for one...
Thank you sir. I will dig into that.
Almost 200 views and not a single comment? How about this, How much would it cost to convert a PM 45 mill to 3 axis cnc? A realistic higher end setup.
I am an engineering student at Oregon State and I am in my second term of Solidworks and I start MasterCAM next term and I was wondering about the practicality of making a Precision Mathews PM-45M...