Search:

HI,
I have n ANCA Rgx machine , its A axis Rotory motor ecoder failed.
i want to replace this encoder , It is a siemns made motor for ANCA. With analog incremental encoder(Heidenhain ERN...

Yes Potomag, you said right , I have replaced the tacho , now it is working fine. thanks 4 the reply .

I'm using DC permanent magnet servo motor with carbon brush for the our Unison CNC tool grinder .
im facing some problem on this motor . Motor is continuously rotating when i'm giving signal hold...

it was the problem with it's cable , thanks for your reply

I have A Rollomatic 600X machine with auto loader.


Machine name : Rollomatic CNC 600X
Serial no : 346
Control : fanuc series 16 iM

It has X,Z axis on horizontal movement and Y is vertical....

I have a makino seiki tool grinder with fanuc 18iMB5 controls+

im facing a problem-

Alarm : 070 NO PROGRAM SPACE IN MEMORY


if im loading new part program this alarms displays

yes u r right , we could to find lot of moister in the system , and i mentioned about height why bcz , if the water stored in low portion of pipe(between receiver and drier) there is no way to escape...

2" pipe line from compressor to drier not under ground, but level less than any other part of the system, plant B consuming 80 CFM.please refer the attachment also. please help me, ur advice will be...

I’m facing low pressure problem at plant “B” , compressor discharge pressure getting sufficient (6bar)and receiver out let pressure also shows the same pressure(6), but at point of use ( inside the...