A quick stab in the dark as have a snack ! Check some of your 2d contour paths , you might have tab cutoffs selected in there when you didnt mean to
Type: Posts; User: MachinistDan
A quick stab in the dark as have a snack ! Check some of your 2d contour paths , you might have tab cutoffs selected in there when you didnt mean to
if your simply just simulating it in mastercam turn up your quality setting...in x8 its a little bar in the lower right hand corner called Precision... it improves the picture,and you wont see...
Appreciate the response !
underthetire
I am programing in metric
Mactec54
Im using wear compensation though so it really shouldnt matter :S!
"the beauty of wear comp is your lead in and...
It happened again.... runs perfectly in Graph on screen .. but when i try to run the program it holds on N8 ... it wont single block past that point either...
O2609
(T2| 1/2 FLAT...
im having thie exact same issue as above ^^ ( baldsym )
1998 Haas VF0
The mill just sits there no alarm no movement ?? I try'ed single blocking through the program to see if i could spot the error, but it single blocks through it perfectly doesn't stop,...
Hi first time on this sight, Still in learning phase on Mastercam creating a Flowline toolpath for a Form roller...toolpath will machine all Rads but will cut back on itself at end of selected...
Hi first time on this sight, Still in learning phase on Mastercam creating a Flowline toolpath for a Form roller...toolpath will machine all Rads but will cut back on itself at end of selected...