CNC CAT
https://www.mechatron-gmbh.de/en
Type: Posts; User: Machinaria
CNC CAT
https://www.mechatron-gmbh.de/en
Just in case anyone need a quick tool change adapter for your china spindle 80mm and 65mm
here are some options
364114364116
this one is for 65mm spindles
Automatic Tool Changing Systems CNC CAT364112
https://www.mechatron-gmbh.de/en/
under $1000
363984
Hello all my name is Anna. I would like someone with experience in VB to write a MACH3 MACRO for me.
I need my machine to perform the following sequence on tool change.
step1 Z AXIS HOME
...
I am pretty new to machining and looking to making a tslot table of hot rolled steel to use 7/16 tslot nuts or 3/8.
Please if anyone know what tslot cutter to use and where I may purchase it. ...
THK GL15N ballscrew Linear Actuator CNC Router | eBay
may I ask where you purchased all your electronics from?
181460
almost done with the frame
I am going to need some help with the electronics
Please post some advice on the best nema 34 setup, (power supply and drivers?...
http://i1076.photobucket.com/albums/w460/giazijune12/IMG_4522_zps6691ccad.jpg
The machine will have its own steel frame base , I'm planning to build a full covered frame for it since I will add a flood system.
just finished making all the brackets :bat:
http://i1076.photobucket.com/albums/w460/giazijune12/IMG_4519_zps57e94d45.jpg...
what are the specs on those?
size of rails?
Got the parts on Ebay
Have just started the Y axis assembly
Any advice is welcomed
180060
180061
I use white lithium grease and it works just fine
Thank you very much!! I have been looking for wiring diagrams and such without any luck. I will give this a go and post a wiring diagram if I get lucky.
Best regards
Anna
the CM101 has a relay that is rated 24V
so does that mean it can connect directly to the board?
does the diode need to be facing certain way? and is there a specific diode to use.
Thank you so...
I have a CM101 breakout board and I need to know how to wire a 24V pneumatic solenoid to it.
How to connect a 24V pneumatic solenoid to CNC breakout board.
sorry I made a mistake it should be under half a mill. Calcium sulfate heats up tremendously fast to allow the laser to melt the metal.
about 1 millimeter depending on the machine you are using, the Formula will also cut aluminum foil.
best regards
www.machinaria.com
A honeycomb is used to vector cut parts to reduce the back of the piece from burning, remember that the laser beam can be reflected of a metal panel. You can also use Plaster of Paris reduced 50/50...
sometimes it helps to reinstall the software and the drivers because you could have change some setting without realizing it.
what is the problem maybe someone here can give you some guidance.
Best regards
if you don't mind me asking, why cant you vent them out of the complex? rules and regulations?
what is your budget? a laser engraver that can gut Carbon fiber in different angles should be around 60 to 100k.
Best regards
You can reduce the Plaster with alcohol 1:1 ratio but make sure you wait till the formula dries completely.;)
If you guys are interested you may also cut aluminum foil with the laser engraver using the compound. If you are reducing with alcohol make sure you let the formula dry completely before vector...
Mcphil you've got PM.
Best regards
You can replace the chrome polish with rubbing alcohol.:):)
Machinaria