Hi,Abfa.
Look this links.:)
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?action=browse&diff=1&id=SectionsAxis
http://linuxcnc.org/EMC2_User_Manual.pdf
Type: Posts; User: Lucas-10
Hi,Abfa.
Look this links.:)
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?action=browse&diff=1&id=SectionsAxis
http://linuxcnc.org/EMC2_User_Manual.pdf
Yes, but encoder speed max. 1,000,000pps and Iout max = 20ma.
Hi :)
Try this link http://www.rutex.com/pdf/R991h.pdf
Hi, Chivo.
Change 47K resistors to 10K on CS Out.
By Alan:
Use this equation to work out the resistors you need for your motor's current
limits :-
<resistor in ohms> = 20000 / <current in...
Nice release. :)
I’ve same result the motor not spin. :frown:
Thanks.
Hi Allan.
I use old parts from another board (crap board)
and can’t read revision numbers, sorry.
I bought 3 new PIC’s and its work very fine.
Thanks.
Now is work fine after change PIC. :eek:
With unloaded stepper motor (HT23-400 264oz-in, 2.8A),
I can turn 300rpm without any resonance (8micro-stepper).
Very nice board and firmware. :) ...
Hi all, :)
I have the same problem.
Any idea to solver this?
Thanks.