Search:

Thanks all, you are the great People.

And also the CNCZONE by which I will remain intuch with you.

Yes I got that switch in the electric panel at back side of machine.

I can not explain in...

Thanks all,
I have got those shear pins. yes pins were broken.
l have replaced those pins and the alarm was gone.

But now machine is moving its all axes only in "MANUAL" mode. When I have...

Hello all,

Ok ! I have purchased a second hand Tiwan brand cnc milling machine with SINUMERIK 802D controller and SIMODRIVE 611.

Couple of days ago due to electric shock, machine was stoped...

Hello all,

Ok ! I have purchased a second hand Tiwan brand cnc milling machine with SINUMERIK 802D controller and SIMODRIVE 611.

Couple of days ago due to electric shock, machine was stoped...

Hello all people,

I have purchased a Old Okuma LB 15 twin turret turning machine.
When I have powered on theis machine, There is alarm appeared on screen " ALARM 206 A Shear pin 4"
I have...

Yes, you are right.

Ok !!!!

I have Taiwan brand machine with Fanuc OMC controller, also at the same condition i.e. "There is no G127 address in PMC ladder, so No tape mode sellector switch and No M code for DNC Tape...

Ok !!!!

I have Taiwan brand machine with Fanuc OMC controller, also at the same condition i.e. "There is no G127 address in PMC ladder, so No tape mode sellector switch and No M code for DNC Tape...

According to parmeter list given by machine tool builer in 18i/16i/21i Fanuc controller following is the paramter for memory,either it is use to add the addition memory hardware then set the bits...

Hello every body,

Ok ! I have a taiwan brand vertical CNC machining center with fanuc OMC controller,I wana to attach a swarf chip conveyer with it.
Due to which i have to change its PLC ladder,...