Search:

Andre,

Thank you for the quick reply, tried your suggestion over the weekend and it worked like a charm. Just beginning to play with the software since I bout it over a year ago. No problems so...

Hi All,

The Tooling Definition window seems to have disappeared from my machining module. The Program Operation window is still visible, however when I define a tool it does not show up. I tried...

Not up to speed alarm comes up pretty quick. About 5 to 8 seconds after spindle command. Doc you might be right on the 10 second ramp-up speed being too slow.

Hi All,

Finally got by buddy to come down help swap out my dead Yaskawa 616G3 VFD for a Hitachi WJ200-075LF. I settled on the 10HP Hitachi from Drives warehouse based on

information gleaned...

Just found out the Yaskawa/Safronics spindle drive in myThree J425 is toast. Has anyone replaced any of the old Yaskawa’s with a newMitsubishi, Hitachi or any other brand? Machine build 1993 with a...

Underthetire, thanks for your response, it explains a lot. I will appreciate if anyone can post a simple Dynapath G Code program that uses a couple of (E) fixture offsets and has more than one tool....

Hi All,
Been out of CNC machining for a while now, looking to get back into it again slowly. Just bought a Tree J425 with Dynapath Delta 20 control. Powered up this weeked and was able to home and...

Hello All,
I’ve been an on and off lurker for a few years now. Most of my experience was on older OKUMA, IKEGAI, MHP, and CENTURN machines. Been mostly out of CNC machining for a little over 10...