To All,
The order has been filled
Thank you for your inquires.
Andrew
Type: Posts; User: Florymachine505
To All,
The order has been filled
Thank you for your inquires.
Andrew
Shipped to New Jersey
Hello,
I am looking to have 100 parts as attached machined from Nylon 6/6.
These are cupseals for a pressure vessel the center hole needs to be press fit on a shaft so that tolerance is fairly...
Fastest, wish I knew that before I spent all that time lol I will probably give it a shot if I dont like the accuracy I have now when I do a few test parts.
Small update.
I got the spindle...
Another update for the day.
It took a long time with my process but I got the motors tuned in!!! Basically I knew the phase angle on my steppers but that is really it, I did not know how many...
Update...
Got the vistacnc pendant in and it is a very nice product. Wired the steppers together, I seen how they were wired in the bus bar and just assumed that the black and brown wires should...
Linked the smooth stepper board to the computer no real drama there just followed the instructions and copied and pasted the files into the correct area of mach and all was well until I get this...
Ok another small update.
I received the second computer to replace the initial one. I am happy that they are the same computer, I stole the ram out of the dead computer, the floppy drive, the...
I really love this forum so many responses from people that actually know what they are doing.
The reason for me keeping the steppers is that they are already run through and have been running...
Update my computers mother board fried out today funnily enough. I ordered another computer off ebay for $80 its pretty much the same computer funny enough so if something happens I have parts as an...
New here but I have lurked for a long time to figure out how to go about doing this. First I am pretty terrible with electronics and this is all completely not in my realm of comfort but screw it I...