No feed rate error in FeatureCam

I have a Bridgeport Torqcut 22 with a DX32 controller. When I program a part from an IGES file using FeatureCam (v6.0) and load it into the Bridgeport, the mill stalls when I try to run it and gives me a No feedrate specified error message. The txt program looks identical to one that runs fine which I have written using geometry created in Fcam itself; any ideas?
I am using the torqcutti post processor. Both programs run through the simulation mode in Fcam without problem.
Thanks
Jensen

Quote:

---

Originally Posted by drj_95018

The txt program looks identical to one that runs fine which I have written using geometry created in Fcam itself; any ideas?

---

Looks identical at the controller? Looks identical in notepad?

If so, you have some sort of ghost character in there.

I had a similar problem. I would re-type the line that alarmed out at the controller and it would work fine. A "Legacy Programmer" (what we call the old guys) I work with recommended opening the txt file with 2010 Word and re-saving it, it worked. I then dug into the post processor and corrected the issue.

Hope this helps