Verify or Backplot Manual Code

Under the Toolpath Menu there is the "Manual Code..." option where you can type or upload g-code text.

Is there anyway that Mastercam can simulate this code with Verify or Backplot.

If not, can anyone suggest decent verification software that isn't too costly, or even free? Years ago I used Predator Virtual which worked great. I'm not sure what it cost these days.

Here's one, called NC Corrector

load it into the editor AFTER posting, seems OK for basic 3 axis work

LINK to site

SM,

What a great little program!

Although it doesn't simulate the cutting it shows the tool path very nicely. It installed very easily, it's obvious how to use the software and free to boot.

Tony