Siemens 810D Hardinge 600II control shutting down
Hi
Can anyone help? My Hardinge 600II with Siemens 810D control keeps shutting down and rebooting. It does this while both machining and when not. When it starts rebooting it continually does it and doesn't actually fully load up! I have to turn it off and and on to get it to load up fully... then after a short while it starts rebooting again....
Re: Siemens 810D Hardinge 600II control shutting down
Tough one! I would think that it is a bad switch, relay, or connection. Try having the cabinet open and watching it, in the dark maybe too!
Can't help more without more information.
Mike
Re: Siemens 810D Hardinge 600II control shutting down
Sounds like to me it's a software issue within Windows. Do you have a backup of the control software to reload?
Re: Siemens 810D Hardinge 600II control shutting down
Quote:
Originally Posted by
gunrights
Sounds like to me it's a software issue within Windows. Do you have a backup of the control software to reload?
WINDOWS?
Re: Siemens 810D Hardinge 600II control shutting down
yes Microsoft Windows.............. what do you think the operating system is behind the HMI. Embedded version of Microsoft Windows. I think if you push and hold either the number three or six key when it's booting it will take you into Windows. There should be a way of restoring. Make sure you backup your programs.