Puma 200 Lathe turret issue
Hello, I have used this site before but have never asked my own questions. So here goes, I am working on a 1997 Puma 200 Lathe 12 tool turret, the shaft broke, fixed shaft and replaced o - rings, now the turret keeps going around and it can't seem to find it's place and will not lock in place, every so often often it will but encoder doesn't light up, any suggestions?
Re: Puma 200 Lathe turret issue
Offhand, sounds like a prox switch isn't picking up and a rotary encoder is out of line.
Re: Puma 200 Lathe turret issue
This user has been in touch with me, Doosan Service, and it was found that the encoder was not sending a signal at all.
The encoder was ordered and replaced.
As I was out of the office at the time, User was advised to determine the position requirements by verifying the I/O reading we=hen the light on the encoder lit up.
remaining instructions were to clamp into the required position, and align the light window to orient the encoder correctly.
She has not called back, so my assumption is that it worked. I will call her to verify by tomorrow.
Re: Puma 200 Lathe turret issue