Printable View
I have done the Zero return adjustment for Error EX0296 (224).
But it does not work on this one, So I'v been searching the website for information on (411) after the EX0296. And I have come up empty.
I would really appreciate if any one can help me figure this out.
Thank you.
Might really help to know what machine we are talking about. I'm guessing its a horizontal with that alarm?
Sorry about that, Yes it is a horizontal. Mori Seiki SV-400, the servo amplifier unit is flashing *U and II*
Sv is a vertical. Sh-400? It makes a difference since the horizontals use a Fanuc power mate for the magazines, most of the verticals don't.
Yes your right it is a vertical my apologizes
Is this a Fuji drive on this one, or a schnieder?
The drive is Fanuc and the servo amplifier unit is Fanuc
P/N A06B-6093-H152
EA7700258
Ok, see if you have PMM listed when you press the system key. Some machines had the power motion manager (pmm) and would let you look at diagnostic bits for the ATC through that.
Yes, this machine does have the PMM list
Ok, let me find the parameter for zero return. if the machine won't let you set it normally, you can lie to it and set zero where it is, then index the magazine to #1 and toggle the bit.
OK thank you.
I figured out the reason the magazine servo motor was not rotating CHIPS got in between the gears and it was gamed up, cleaned it up did the zero return and and it was all good.
Thank you for the help.
Can you detail me about machine system and take photo the 1815 parameter?
Can you detail me about machine system and take photo 1815 parameter?