Printable View
Hello,
I have to replace a controller card on my 93 88hs. It currently has a 1010-4 card. Unless I misread the interchange chart (always a possibility) either would work in my mill. The 1010-1 is cheaper but I don't want to lose functionality. Could you tell me the difference between the 1010-1 and the 1010-4?
Thanks, Shepard
oops, I think I did misread the interchange chart. I have a 1400-4 CPU so 1010-1 won't work.
From 1992 up to the early part of 1994 fadal used a 1400-4 card with -3 software. You can use a 1010-4 up to a 1010-6 but not a 1010-1.
Thank you. Other than the jumper is there anything I need to do to swap in the new card? Seems I remember something about parameters being stored on cards... Ill look it up but if you know off the top of your head I'd appreciate it.
Thanks
Are you Shepard629 on ebay? i just sold a 1010-4 today.
Yep, thats me. Sorry I didn't catch your post. Its been a bit since I visited the forum. About to install the card and see if I can get running again.
I forgot to pull the eproms, replace eproms with yours and reset jumper for your axis