Re: 50watt laser cnc arcing
what machine is it?? it sounds like your power supply is out and you need a new one . but I would recommend also to put a mA meter ( 50mA) in the negative ( black or blue) line of the laser tube.
you probably also need a new tube
greetings
waltfl
Re: 50watt laser cnc arcing
Hello herby,
Do i have to break the cathode connection to measure that?? If i connect one end of the meter to the black/blue cable where does the other end of the meter go??
Can i use a clamp meter to measure it??
Thanks
Re: 50watt laser cnc arcing
hi stiyke
yes the thin wire what goes to the side on the tube where the beam comes out ( this is one side of the meter, and the other side of the meter goes to the powersupply), but cut this wire somewhere inside and put eventually extension wire on it . don't cut the thick red wire!
no a clamp on will not work.
this mA meter ( best a analog) should always be connected and you need to make sure that the current does not go over 25mA or you will destroy your tube in just a few hours.
id you got more question you can send me a PM
greetings
waltfl
Re: 50watt laser cnc arcing