-
Software change request
Using Mach3.
I'm not sure if I'm doing this right, but when I go to zero a tool and set the offsets for my part location, I have to click the Jog % way down, sneak up on my part, then click 30+ time to increase the jog to do something esleware!
Could you please place a max button or a key combo like <SHIFT><CLICK> for the jog, that would pop it back to 100%?
( If I only had a Manual Pulse Generator & a pendant! :tired: )
Thank you,
Eric A. Arnold
-
Hold down shift while jogging for fast jog. :) Set your slow jog to something like 5%, hold down shift and jog down close. Then use the slow jog to get your zero. Hold down shift to jog quickly back up.
-
Thanks for the reply Gerry, I'll try that!
Eric