2 Attachment(s)
Help with wiring Drivers and breakout board please :)
Hey Everyone.
I purchased a set of 4 NEMA 42's from Automation Technologies and a breakout board from China.
I am trying to figure out how to wire it up to the drivers. I can't figure out Pulse, Dir, etc. hook ups to the board.
I hope you guys can help me with this.
Here is a photo of what I am trying to hook up.
Also here is the manual for the breakout board.
Thanks for any help in advance :)
Dezi
Re: Help with wiring Drivers and breakout board please :)
I must admit, the breakout board is far from the same quality as the drives and motors...
But your motor outputs from your BOB need to be connected to PUL +- and DIR+-. How exactly they need to be connected should be explained in any documentation you recieved with your BOB.
Your motors are connected to the drives on the drives A+- and B+-
And your drives should be connected to AC on the AC input in the bottom.
Re: Help with wiring Drivers and breakout board please :)
theres a chart in the pdf...
example P6 = X step
first photos shows P locations, and numbers
from chart match them >>>>>> page 5
just make first a layout and organize the part.. then draw where wires are running..then you will make it easy...