-
EZ-Trak - b3t.exe
I have been trying to diagnose our EZ-Trak at the shop here and all problems are pointing to the BMDC board. From reading this forum, there appears to be a utility to help confirm this, B3T.exe. I am unable to find this file anywhere on the machine or our installation floppies. If someone could assist me with obtaining this file, I would greatly appreciate it!
Thank you for your time!
-
I have the B3t.exe that is for a TC-22 mill,don,t know if its the same.
Looks like it detects BMDC3L,BMDC3 or BMDC4
If someone can confirm its the same file you need I can email it to you.
-
tpmx57,
Being that no one has responded yet -- Would you mind submitted the file anyways? BMDC3 sounds quite familiar, but I would have to pull the board to verify.
Thanks again.
-
B3T is only one version. The early boards ( BMDC in 2 axis EZTRAKs) do not identify themselves to the test but it can still be run.
Hard to transfer a exe file. Most firewalls stop it.
George
-
Thanks for the information machintek. To bypass the firewalls, you can easily zip the file before sending via email. Alternatively, if anyone can help, I can provide FTP information to assist in the transfer. Private message me for contact information on how to send the file.
Thanks!
-
Perhaps a Email address to send to?
George
-
You may send the file via email to dslezak at gmail.com
Thanks in advance!
-
Re: EZ-Trak - b3t.exe
Can anybody send me the file B3T.exe to lopez.cl.rodrigo at gmail.com?
I appreciate so much your help
Rodrigo